Table of Contents
Advertisement
mGuard pci
170
Innominate Security Technologies
9.5
Configuration in Stealth mode
Installing the PCI card
•
If the PCI card has not yet been installed in your computer, first proceed as described
under "Installing the hardware" on page 164.
Installing the drivers
•
If you have configured the mGuard for Driver mode, make sure that the drivers are in-
stalled as described under "Installing drivers" on page 165.
Configuring the network interface
If the mGuard
–
Is operated in Driver mode and the LAN interface (network interface of the computer)
has not yet been configured or
–
Is operated in Power-over-PCI mode and the network interface of the computer that
is connected to the LAN interface of the mGuard has not yet been configured
This network interface must be configured before the mGuard can be configured.
Under Windows XP, proceed as follows to configure the network interface:
•
Click on "Start, Control Panel, Network Connections".
•
Right-click on the LAN adapter icon to open the context menu. In the context menu,
click on "Properties".
•
In the "Properties of local network LAN connections" dialog box, select the "General"
tab.
•
Under "This connection uses the following items", select "Internet Protocol (TCP/IP)".
•
Then click on "Properties" to display the following dialog box:
Figure 9-11
Internet Protocol (TCP/IP) Properties
Default gateway
Once you have configured the network interface, you should be able to access the
mGuard's configuration interface with a web browser by going to the URL "https://1.1.1.1/".
I15007_en_02
Advertisement
Table of Contents
