Table of Contents
Advertisement
Requirements
I15007_en_02
•
Open the computer cover. Please refer to the description in the computer user manual
for this step.
•
Select a free PCI slot (3.3 V or 5 V) for the mGuard pci.
•
Remove the corresponding slot plate by loosening the relevant screw and pulling out
the slot plate.
Keep the screw for securing the mGuard pci card.
•
Carefully align the pin strip of the mGuard pci card over the socket strip of the PCI slot
on the motherboard and then press the card evenly into the socket strip.
•
Tighten the card slot plate.
•
Close the computer cover again.
•
Connect the computer power cable again and switch on the computer.
9.3.4
Installing drivers
Driver installation is only required and supported if the mGuard pci is operating in driver
mode (see "Driver mode" on page 160).
–
If necessary, follow the steps described in "Installing the hardware" on page 164.
–
You should have the driver files on a data carrier.
If not:
•
Download the driver files from the download area at www.innominate.com.
•
Extract the files from the ZIP.
•
Copy the extracted files to a data carrier, e.g., CD-ROM, USB memory stick.
mGuard pci
Innominate Security Technologies
165
Advertisement
Table of Contents
