Innominate mGuard Reference Manual page 139

I15007_en_02
After the rescue procedure has been started by pressing the Enter key, the required data is
downloaded from the medium that was connected/inserted to/into the device.
Start rescue procedure from CD/DVD
Requirement: The firmware of the mGuard has been previously burnt to CD/DVD (see
below under "Burning the mGuard firmware to CD/DVD-ROM" on page 140).
Effect: The mGuard downloads all necessary files from the inserted CD/DVD.
With this in mind, while the boot menu is displayed and before applying this selection,
insert the CD/DVD with the mGuard firmware into the CD/DVD drive.
(For security reasons, the mGuard centerport² does not boot from the CD/DVD).
– Once the rescue procedure is complete, a corresponding message appears on the
monitor. Follow any further on-screen instructions.
Start rescue procedure from USB stick (USB Flash drive)
Requirement: The firmware of the mGuard has been previously copied to a USB stor-
age medium (USB stick, USB Flash drive).
/Firmware/install.x86_64.p7s
/Firmware/firmware.img.x86_64.p7s
Effect: The mGuard downloads all necessary files from the connected USB storage
medium. (For security reasons, the mGuard centerport² does not boot from the USB
storage medium).
– Once the rescue procedure is complete, a corresponding message appears on the
monitor. Follow any further on-screen instructions.
mGuard centerport²
Innominate Security Technologies
139