Innominate mGuard Reference Manual page 210

mGuard centerport
Objective
Action
210
Innominate Security Technologies
11.8.1 Performing a recovery procedure
The network configuration (but not the rest of the configuration) is to be reset to the delivery
state, as it is no longer possible to access the mGuard.
When performing the recovery procedure, the default settings are established:
Table 11-5 Preset addresses
Default setting
mGuard centerport
The settings configured for VPN connections and the firewall are retained, including pass-
words.
Possible reasons for performing the recovery procedure:
– The mGuard is in PPPoE mode.
– The configured device address of the mGuard differs from the default setting.
– The current IP address of the device is not known.
Up-to-date information on the recovery and flashing procedure can be found in the appli-
cation note for your mGuard firmware version.
(Application notes are available in the download area at www.innominate.com.)
Requirement: a monitor and a keyboard are connected to the device.
• Press the following keyboard shortcut: <Alt>+<SysRq>+<a>.
(On English keyboards the German <S-Abf> corresponds to <SysRq>. However, some
keyboards do not feature the <SysRq> key. In this case, use the <Print> key.)
Once the recovery procedure is complete, a corresponding message appears on the mon-
itor.
Network Management IP #1
mode
Router
Management IP #2
https://192.168.1.1/
I15007_en_02