Table of Contents
Advertisement
Objective
Action
I15007_en_02
10.7.2
Performing a recovery procedure
The network configuration (but not the rest of the configuration) is to be reset to the delivery
state, as it is no longer possible to access the mGuard.
When performing the recovery procedure, the default settings are established:
Table 10-5
Preset addresses
Default setting
mGuard blade controller
The settings configured for VPN connections and the firewall are retained, including pass-
words.
Possible reasons for performing the recovery procedure:
–
The mGuard is in PPPoE mode.
–
The configured device address of the mGuard differs from the default setting.
–
The current IP address of the device is not known.
Up-to-date information on the recovery and flashing procedure can be found in the appli-
cation note for your mGuard firmware version.
You can find application notes under the following Internet address:
www.innominate.com.
•
Slowly press the Reset button six times.
After approximately 2 seconds, the LAN LED lights up red.
•
Press the Reset button slowly again six times.
If successful, the LAN LED lights up red.
If unsuccessful, the WAN LED lights up red.
If successful, the device restarts after two seconds and switches to Router mode. The de-
vice can then be reached again under the corresponding addresses.
Network
Management IP #1
mode
Router
–
mGuard blade
Management IP #2
https://192.168.1.1/
Innominate Security Technologies
193
Advertisement
Table of Contents
