Operating Elements And Leds - Innominate mGuard Reference Manual

mGuard rs4000/rs2000 3G
Reset button
LEDs, see Table 3-2
LAN port (protected)
LAN port (protected)
LAN port (protected)
LAN port (protected)
Slot for optional SD card
LEDs, see Table 3-2
Table 3-2 LEDs on the mGuard rs4000 3G and mGuard rs2000 3G
LED State
P1 Green
P2 Green
Stat Green
Err Red
Stat + Err Flashing alternately:
green and red
Mod Green
Fault Red
52
Innominate Security Technologies
3.1

Operating elements and LEDs

1
2
3
WAN port
4
DMZ port
5
6
7
8
9
10
Antenna sockets
– SMA (mobile communi-
cation)
– RSMA (GPS)
Figure 3-2 Operating elements and LEDs on the mGuard rs4000 3G
Meaning
On Power supply 1 is active
On Power supply 2 is active (mGuard rs2000 3G: not used)
Flashing Heartbeat. The device is correctly connected and operating.
Flashing System error. Restart the device.
– Press the Reset button (for 1.5 seconds).
– Alternatively, briefly disconnect the device power supply and then connect it
again.
If the error is still present, start the recovery procedure (see Page 69) or contact
your dealer.
Boot process. When the device has just been connected to the power supply.
After a few seconds, this LED changes to the heartbeat state.
On Connection via modem established
On The signal output takes low level due to an error (inverted logic). The signal output
is inactive during a restart.
12
SMA
11
RSMA
For plug-in screw terminal
blocks, assignment, refer to
Page 57 and Page 62
13
RS-232 interface
14
Slot for SIM
card 1
15
Slot for SIM
card 2
I15007_en_02