Table of Contents
Advertisement
mGuard pci² SD
SD card slot (configuration
memory)
Reset button
RJ45 socket (LAN 1) for
connecting to the internal
network
RJ45 socket (WAN 1) for
connecting to the external
network/Internet
Table 5-2
LEDs on the mGuard pci² SD
LEDs
State
WAN 1
Green
On
Off
LAN 1
WAN 2
Yellow
On
Flash-
LAN 2
ing
Green
On
Flash-
ing
LAN 1
Various LED light
LAN 2
codes
WAN 1
STAT
Red/green
Flash-
ing
Green
Flash-
ing
Red
Flash-
ing
92
Innominate Security Technologies
5.1
Operating elements and LEDs
Extension connection (LEDs, Reset button, SD card)
Figure 5-2
Operating elements and LEDs on the mGuard pci² SD
Meaning
Full duplex
Half duplex
10 Mbps
10 Mbps, data transmission active
100 Mbps
100 Mbps, data transmission active
Recovery procedure/flashing
See "Restart, recovery procedure, and flashing the firmware" on page 104.
Boot process. When the device has just been connected to the power supply. After a few
seconds, this LED changes to the heartbeat state.
Heartbeat. The mGuard is connected correctly and ready to operate.
System error. Restart the device.
•
Press the Reset button (for 1.5 seconds).
•
Alternatively, briefly disconnect the device power supply and then connect it again.
If the error is still present, start the recovery procedure (see "Performing a recovery proce-
dure" on page 105) or contact your dealer.
Battery (can be replaced)
STAT LED
LAN 1 LED
LAN 2 LED
WAN 1 LED
WAN 1 LED
I15007_en_02
Advertisement
Table of Contents
