Table of Contents
Advertisement
I15007_en_02
11.4.3
Configuration in Router mode
By default upon delivery, following reset to the default settings or after flashing the
mGuard, the mGuard can be accessed within the network 192.168.1.0/24 via the LAN in-
terface under IP address 192.168.1.1.
To access the configuration interface, it may be necessary to adapt the network configura-
tion of your computer.
Under Windows 7, proceed as follows:
•
In the Control Panel, open the "Network and Sharing Center".
•
Click on "LAN connection". (The "LAN connection" item is only displayed if a connection
exists from the LAN interface on the computer to a mGuard in operation or another part-
ner).
•
Click on "Properties".
•
Select the menu item "Internet protocol Version 4 (TCP/IPv4)".
•
Click on "Properties".
•
First select "Use the following IP address" under "Internet Protocol Version 4 Proper-
ties", then enter the following address, for example:
IP address:
Subnet mask:
Default gateway:
Depending on the configuration of the mGuard, it may then be necessary to adapt the net-
work interface of the locally connected computer or network accordingly.
192.168.1.2
255.255.255.0
192.168.1.1
mGuard centerport
Innominate Security Technologies
205
Advertisement
Table of Contents
