Restart, Recovery Procedure, And Flashing The Firmware - Innominate mGuard Reference Manual

mGuard delta²
Objective
Action
86
Innominate Security Technologies
4.8 Restart, recovery procedure, and flashing the firm-
ware
The Reset button is used to set the device to one of the following states:
– Performing a restart
– Performing a recovery procedure
– Flashing the firmware/rescue procedure
Figure 4-5 Reset button
4.8.1 Performing a restart
The device is restarted with the configured settings.
• Press the Reset button for around 1.5 seconds until the ERR LED lights up.
(Alternatively, disconnect the power supply and then connect it again.)
Reset button
I15007_en_02