Table of Contents
Advertisement
mGuard pci
Requirement
How to proceed
Example
Configuration
174
Innominate Security Technologies
9.7
Remote configuration
The mGuard must be configured so that remote configuration is permitted.
The option for remote configuration is disabled by default.
Switch on the remote configuration option in the web interface under "Management >> Web
Settings".
To configure the mGuard via its web user interface from a remote computer, establish the
connection to the mGuard from there.
Proceed as follows:
•
Start the web browser on the remote computer.
•
Under address, enter the IP address where the mGuard can be accessed externally
over the Internet or WAN, together with the port number (if required).
If the mGuard can be accessed over the Internet, for example, via address
https://123.45.67.89/ and port number 443 has been specified for remote access, the fol-
lowing address must be entered in the web browser of the remote peer:
https://123.45.67.89/
If a different port number is used, it should be entered after the IP address, e.g.,
https://123.45.67.89:442/
The mGuard can then be configured via the web interface. For additional information,
please refer to the software reference manual.
I15007_en_02
Advertisement
Table of Contents
