Technical Data - Innominate mGuard Reference Manual

Hardware properties
Platform
Network interfaces
Other interfaces
Drives
Redundancy options
Power supply
Power consumption
Temperature range
Humidity range
Degree of protection
Dimensions (H x W x D)
Weight
Firmware and power values
Firmware compatibility
Data throughput (router | firewall)
Hardware-based encryption
Encrypted VPN throughput (AES-256)
Management support
Diagnostics
Other
Conformance
Special features
I15007_en_02
6.9

Technical data

mGuard smart²
Freescale network processor
with 330 MHz clocking
1 LAN port | 1 WAN port
Ethernet IEEE 802.3 10/100 Base TX |
RJ45 | full duplex | auto MDIX
Serial via USB connection
–
Depending on the firmware used
Via USB interface (5 V at 500 mA)
Optional: external power supply unit (110 V ... 230 V)
2.5 W, maximum
0°C ... +40°C (operation)
-20°C ... +60°C (storage)
20% ... 90% during operation, non-condensing
IP30
27 x 77 x 115 mm
131 g
For mGuard v7.2 or later: Innominate recommends the use of the latest firm-
ware version and patch releases in each case.
For the scope of functions, please refer to the relevant firmware data sheet.
Router mode, default firewall rules, bidirectional throughput: max. 99 Mbps
Stealth mode, default firewall rules, bidirectional throughput: max. 50 Mbps
DES | 3DES | AES-128/192/256
Router mode, default firewall rules, bidirectional throughput: max. 35 Mbps
Stealth mode, default firewall rules, bidirectional throughput: max. 25 Mbps
Web GUI (HTTPS) | command line interface (SSH) | SNMP v1/2/3 | central
device management software
3 LEDs (in combination for boot process, heartbeat, system error, Ethernet
status, Recovery mode) | Log File | Remote Syslog
CE | FCC
Realtime clock | Trusted Platform Module (TPM) | temperature sensor
mGuard smart²/smart
Innominate Security Technologies
123