Table of Contents
Advertisement
mGuard rs4000/rs2000 3G
Input/CMD I1, CMD I2
Operating a connected
push button
Operating a connected
on/off switch
Signal contact (signal out-
put) ACK O1, O2
Alarm output ACK O3
Operating a connected
push button
58
Innominate Security Technologies
Service contacts as of firmware version 8.1
Via the web interface under "Management, Service I/O", you can set whether a push button
or an on/off switch has been connected to the inputs. One or more freely selectable VPN
connections or firewall rule records can be switched via the corresponding switch. A mixture
of VPN connections and firewall rule records is also possible. The web interface displays
which VPN connections and which firewall rule records are connected to this input.
The push button or on/off switch is used to establish and release predefined VPN connec-
tions or the defined firewall rule records.
•
To switch on the selected VPN connections or firewall rule records, press and hold the
push button for a few seconds and then release the push button.
•
To switch off the selected VPN connections or firewall rule records, press and hold the
push button for a few seconds and then release the push button.
•
To switch on the selected VPN connections or firewall rule records, set the switch to
ON.
•
To switch off the selected VPN connections or firewall rule records, set the switch to
OFF.
Via the web interface under "Management, Service I/O" you can set whether certain VPN
connections or firewall rule records are monitored and displayed via the LED Info 1 (out-
put/ACK O1) or LED Info 2 (output/ACK O2).
If VPN connections are being monitored, an illuminated Info LED indicates that VPN con-
nections are established.
The O3 alarm output monitors the function of the mGuard rs4000/rs2000 and therefore en-
ables remote diagnostics.
The Fault LED lights up red if the signal output takes low level due to an error (inverted
logic).
The O3 alarm output reports the following when "Management, Service I/O, Alarm output"
has been activated.
–
Failure of the redundant supply voltage
–
Monitoring of the link status of the Ethernet connections
–
Monitoring of the temperature condition
–
Monitoring of the connection state of the internal modem
Service contacts up to firmware version 8.0
The push button or on/off switch is used to establish and release a predefined VPN connec-
tion.
The output indicates the status of the VPN connection (in the web interface under "IPsec
VPN >> Global >> Options").
•
To establish the VPN connection, hold down the button for a few seconds until the INFO
LED flashes. Only then release the button.
Flashing indicates that the mGuard has received the command to establish the VPN
connection and is establishing the VPN connection. As soon as the VPN connection is
established, the INFO LED remains lit continuously.
•
To release the VPN connection, hold down the button for a few seconds until the signal
output flashes or goes out. Only then release the button.
I15007_en_02
Advertisement
Table of Contents
