Bracket Unit; Checking The Ptt Operation; Checking The Ptt Fluid Level - SELVA MARINE Blue Whale 250 EFI Service Manual

8. Check the gear shift for smooth operation,
check the operation of the neutral switch
and, if necessary, repeat steps 3–7.

Bracket unit

Checking the PTT operation

1. Fully tilt the outboard motor up and down
a few times and check the entire trim and
tilt range for smooth operation. Check the
PTT fluid level if necessary.
NOTE:
Be sure to listen to the winding sound of the
PTT motor for smooth operation.
2. Fully tilt the outboard motor up, and then
support it with the tilt stop lever 1 to
check the lock mechanism of the lever.
6P23H11

Checking the PTT fluid level

1. Fully tilt the outboard motor up, and then
support it with the tilt stop lever 1.
3
WARNING
After tilting up the outboard motor, be
sure to support it with the tilt stop lever.
Otherwise, the outboard motor could sud-
denly lower if the PTT unit should lose
fluid pressure.
2. Remove the reservoir cap 2, and then
check the fluid level in the reservoir.
S6P23190
WARNING
Make sure that the trim and tilt rams are
fully extended when removing the reser-
voir cap, otherwise fluid can spurt out
from the unit due to internal pressure.
NOTE:
If the fluid is at the correct level, a small
amount of fluid should overflow out of the
filler hole when the cap is removed.
Control system / Bracket unit
1
2
3
4
5
6
7
8
9
3-12