Enter/Exit Programming Mode
In-Store Printed Label Minimum Read
This feature specifies the minimum number of consecutive In-Store Printed Label decodes
before is accepted as good read.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan your selection from the bar codes below. You'll need to cover any unused bar codes
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
DEFAULT
008502(CR)
In-Store Printed Label Minimum Read = 2
008504(CR)
In-Store Printed Label Minimum Read = 4
262
on this and the facing page to ensure that the scanner reads only the bar code you intend
to scan.
Mode bar code.
008501(CR)
In-Store Printed Label Minimum Read = 1
008503(CR)
In-Store Printed Label Minimum Read = 3
Magellan™ 9800i Scanner