Datalogic Magellan 9800i Product Reference Manual page 31

6. Route the TDR cable down through the base of the scanner (
7.
8. Fully seat the plastic Corner Piece in the grooves intended for it on the scanner frame
9. Verify that the cable is not pinched or caught between assemblies, then connect it to its 8-
10. [Long Scanner/Scale models ONLY] Secure the Back Flange Assembly (
Figure 9. Installing the Optional TDR
Product Reference Guide
it all the way through on the bulkhead side of the base and seating the TDR in its corner
cavity. Make sure it is not pinched or caught beneath the scanner base.
Use a 3mm ball end hex driver to
Figure 9
purpose ( , #7), tightening them evenly to 1.74Nm (15 in-lb).
Figure 9
( , #8).
pin Din connection in the center of the bulkhead (
the Scanner/Scale using the original bolts. Tighten both evenly to 0.79 Nm (7 in-lb).
3
2
1
8
7
secure the TDR with the two bolts provided for this
Figure 9
4
5
9
6
Figure 9
, #6), gently pulling
, #9).
Figure 9
, #1) to
19