Enter/Exit Programming Mode
UPC-A Number System Character Transmission
Enables/disables transmission of a UPC-A number system character.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan either the enable or disable bar code below. You'll need to cover any unused bar codes
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode bar
00D301(CR)
UPC-A Number System Character Transmission = Enable
238
This feature MUST be enabled for IBM interfaces for proper function.
This item is ignored when the advanced feature, Full Label Edit, is
enabled.
NOTE
on this and the facing page to ensure that the scanner reads only the bar code you intend
to scan.
code.
00D300(CR)
UPC-A Number System Character Transmission =
Disable
DEFAULT
Magellan™ 9800i Scanner