Codabar Length 2 - Datalogic Magellan 9800i Product Reference Manual

Codabar Length 2

If Codabar Length Control is set to Fixed-Length decoding, this feature specifies Codabar
second fixed length. If Codabar Length Control is set to Variable-Length decoding, this feature
specifies the maximum label length.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan the barcode,
codes on this and the facing page to ensure that the scanner reads only the barcode you
intend to scan.
3. Scan the appropriate digits from the
label length. The selectable range for this option is 00 (meaning ignore this length), or 03
to 50. Pad all single digit numbers with a leading zero to yield a two-digit entry (03-50).
4. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode bar code.
DEFAULT
Product Reference Guide
When in Fixed Length mode, if Length 2 is set to the value of 00 (zero),
then only Length 1 will apply.
NOTE
Set Codabar Length 2
Enter/Exit Programming Mode
below. You'll need to cover any unused bar-
Keypad Appendix C
in
0239(CR)
Set Codabar Length 2
Default setting for this feature = 50
that represent the desired
337