Enter/Exit Programming Mode
Codabar Start Stop Character Transmission
Enables/disables transmission of Codabar start and stop characters.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan either the enable or disable barcode below. You'll need to cover any unused barcodes
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
009301(CR)
Codabar Start Stop Character Transmission = Enable
328
This item is ignored when the advanced feature, Full Label Edit, is
enabled.
NOTE
on this and the facing page to ensure that the scanner reads only the barcode you intend to
scan.
Mode bar code.
009300(CR)
Codabar Start Stop Character Transmission = Disable
DEFAULT
Magellan™ 9800i Scanner