Enter/Exit Programming Mode
UPC-E Check Character Transmission
Enables/disables transmission of a UPC-E check character.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan either the enable or disable bar code below. You'll need to cover any unused bar codes
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode bar
004001(CR)
UPC-E Check Character Transmission = Enable
244
This item is ignored when the advanced feature, Full Label Edit, is
enabled.
NOTE
on this and the facing page to ensure that the scanner reads only the bar code you intend
to scan.
code.
004000(CR)
UPC-E Check Character Transmission = Disable
DEFAULT
Magellan™ 9800i Scanner