Code 39 Check Character Calculation - Datalogic Magellan 9800i Product Reference Manual

Code 39 Check Character Calculation

Enables/disables calculation and verification of an optional Code 39 check character. When
disabled, any check character in label is treated as a data character.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan either the enable or disable barcode below. You'll need to cover any unused barcodes
on this and the facing page to ensure that the scanner reads only the barcode you intend to
scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode bar code.
DEFAULT
005501(CR)
Code 39 Check Character Calculation = Enable
Product Reference Guide
If check calculation is disabled, the risk is increased that a misread can
occur.
NOTE
Enter/Exit Programming Mode
005500(CR)
Code 39 Check Character Calculation = Disable
295