Enter/Exit Programming Mode
Code 39 Start Stop Character Transmission
Enables/disables transmission of Code 39 start and stop characters.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan either the enable or disable barcode below. You'll need to cover any unused barcodes
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
DEFAULT
022401(CR)
Code 39 Start Stop Character Transmission = Enable
294
This item is ignored when the advanced feature, Full Label Edit, is
enabled
NOTE
on this and the facing page to ensure that the scanner reads only the barcode you intend to
scan.
Mode bar code.
022400(CR)
Code 39 Start Stop Character Transmission = Disable
Magellan™ 9800i Scanner