Standard 2 of 5 Check Character Transmission
Enables/disables transmission of an optional Standard 2 of 5 check character.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan either the enable or disable barcode below. You'll need to cover any unused barcodes
on this and the facing page to ensure that the scanner reads only the barcode you intend to
scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode bar code.
049B01(CR)
Standard 2 of 5 Check Character Transmission = Enable
Product Reference Guide
This feature applies only when
Calculation
is enabled. This item is ignored when the advanced fea-
ture, Full Label Edit, is enabled.
NOTE
Enter/Exit Programming Mode
Standard 2 of 5 Check Character
049B00(CR)
Standard 2 of 5 Check Character Transmission = Disable
DEFAULT
359