Enter/Exit Programming Mode
EAN-13 Check Character Transmission
Enables/disables transmission of an EAN/JAN-13 check character.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan either the enable or disable bar code below. You'll need to cover any unused bar codes
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode bar
00B901(CR)
EAN-13 Check Character Transmission = Enable
250
This item is ignored when the advanced feature, Full Label Edit, is
enabled.
NOTE
on this and the facing page to ensure that the scanner reads only the bar code you intend
to scan.
code.
00B900(CR)
EAN-13 Check Character Transmission = Disable
DEFAULT
Magellan™ 9800i Scanner