OPTIONAL STAND/RISER/MOUNT
Installing the Tilting Stand / Riser
Follow the instructions below to install or remove the Tilting Stand and the Riser.
EAS Cable
Before installing the Stand or Riser, ensure that the EAS cable for your unit (see
page 4
•
If the EAS will be used, be sure the EAS cable is placed into the notch in the enclosure
as shown below.
for accessibility if needed.
•
If the EAS cable is not needed, the EAS cable can be tucked inside the product next to
the host Interface connector.
Installing the Stand
1. To install the bottom cover on the unit, insert the tabs into the bottom of the scanner
at the front edge. If you need access to the EAS cable, feed it through the hole in the
bottom cover.
2. Push up on the back of the bottom cover to snap in place.
6
MAGELLAN™ 1500I
) is secured.
After the stand is installed, the wire can be pulled to extend the wire
Notch
EAS Cable
2
Bottom
Cover
1
Figure 3 on