Enter/Exit Programming Mode
Code 93 Stitching
Enables/disables stitching for Code 93 labels. When parts of a Code 93 barcode are presented to
the scanner with this feature enabled, the barcode parts will be assembled by the scanner's
software, and the data will be decoded if all barcode proofing requirements are met.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan your selection from the barcodes below. You'll need to cover any unused barcodes on
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
06AE01(CR)
Code 93 Stitching = Enable
346
this and the facing page to ensure that the scanner reads only the barcode you intend to
scan.
Mode bar code.
06AE00(CR)
Code 93 Stitching = Disable
DEFAULT
Magellan™ 9800i Scanner