Uconnect Voice Recognition Quick Tips - If Equipped; Introducing Voice Recognition; Basic Voice Commands; Get Started - Jeep GRAND CHEROKEE 4xe 2023 Owner's Manual

54 GETTING TO KNOW YOUR VEHICLE
The heated steering wheel button is located on the
center of the instrument panel below the radio
screen, and within the Climate or Controls screen
of the touchscreen.
Press the heated steering wheel button once to

turn the heating element on.
Press the heated steering wheel button a

second time to turn the heating element off.
NOTE:
The engine must be running for the heated
steering wheel to operate.
WARNING!
Persons who are unable to feel pain to the

skin because of advanced age, chronic illness,
diabetes, spinal cord injury, medication,
alcohol use, exhaustion, or other physical
conditions must exercise care when using the
steering wheel heater. It may cause burns
even at low temperatures, especially if used
for long periods.
Do not place anything on the steering wheel

that insulates against heat, such as a blanket
or steering wheel covers of any type or mate-
rial. This may cause the steering wheel heater
to overheat.
UCONNECT VOICE RECOGNITION QUICK TIPS —
IF EQUIPPED
I V R
NTRODUCING OICE ECOGNITION
Start using Uconnect Voice Recognition with these
helpful quick tips. It provides the key Voice
Commands and tips you need to know to control
your vehicle's Voice Recognition (VR) system.
B V C
ASIC OICE OMMANDS
The following basic Voice Commands can be given
at any point while using your Uconnect system.
Push the VR button on the steering wheel or say
the vehicle's Wake Up word, "Hey Uconnect" or
"Hey Jeep®". The factory default Wake Up word is
set to "Hey Uconnect" and can be reprogrammed
through the Uconnect Settings. After the beep, say:
"Cancel" to stop a current voice session.

"Help" to hear a list of suggested Voice

Commands.
"Repeat" to listen to the system prompts again.

Notice the visual cues that inform you of your Voice
Recognition system's status.
G S
ET TARTED
The VR button is used to activate/deactivate
your Voice Recognition system. You can also use
the system's "Wake Up" word to activate voice
recognition. The "Wake Up" word can be set
through the Uconnect Settings Ú page 214.
Helpful hints for using Voice Recognition:
Reduce background noise. Wind noise and

passenger conversations are examples of noise
that may impact recognition.
Speak clearly at a normal pace and volume

while facing straight ahead.
Each time you give a Voice Command, first push

the VR button or say the "Wake Up" word,
wait until after the beep, then say your Voice
Command.
You can interrupt the help message or system

prompts by pushing the VR button and saying a
Voice Command from the current category.
You can also interrupt the help message or

system prompts by speaking. This feature is
called "barge-in" and can be set through the
Uconnect Settings Ú page 214.