Toshiba Strata CTX28 Programming Manual page 90

System
105 System Data
F
IELD
04 Transfer Privacy
05 Privacy Override
06 Credit Card Code
07 Credit Card Digits
08 E911 Service
09 DR Override by SSD
10 Auto Station Release
11 ISDN SPID
12 Night Mode Relay
13 BGM External Paging
14 Lost Call Destination
15 COS Override Code
4-14
D
ESCRIPTION
Transfer Privacy enabled: CO line buttons that have multiple appearances will only
flash and ring on the transferred-to telephone; the same CO line button on other
telephones will be red-busy.
Transfer Privacy Disabled: CO line buttons that have multiple appearances will flash
and ring on all telephones that have the CO line button appearance.
Possible values: Enable (default) or Disable
Enable Privacy Override Attendant Monitor warning.
Possible values: Enable or Disable (default)
Enter Service Indentifier for Credit Card Calling. If no value is entered in this field
any previously programmed data is lost.
Possible values: Up to 32 digits (default = no value)
Enter the Minimum Dial Digits for Credit Card Calling.
Possible values: 1~66 (default = 21)
Enable E911 Service availability.
Possible values: Enable (default) or Disable
Enable DR Override by System Speed Dial.
Possible values: Enable (default) or Disable
Enable Automatic Station Release.
Possible values: Enable (default) or Disable
Enable Auto Service Profile Identifier (SPID).
Possible values: Operable or Not Operable (default)
Assign BIOU Relay as the Night Relay. This relay activates when the system is in
the Night Mode.
Possible values: 0~8 (default = 0)
BIUO1 provides relays 1 to 4; BIUO2 provides relays 5 to 8
Note On CTX100 the ACTU built-in relay is programmed as relay 5. For this
operation, in Program 100 the BIOU2 must be installed in Cabinet 2, Slot 5,
PCB code 20.
Set the External Page Group Number that includes the external paging zones to
which BGM will be sent. See Program 503
Possible values: 0~4 (CTX100)
0~8 (CTX670 Basic)
0~16 (CTX670 Expanded) (default = 0)
Enter Lost Call Destination. If no value is entered in this field any previously
programmed data is lost.
Possible values: Up to 5 digits (default = no value)
Class of Service Override Code Digits (1-8 digits). The digit length of COS override
codes. COS override codes are set in Program 510.
Possible values: 1~8 (default = 1)
Strata CTX Programming - Part 2: CTX WinAdmin Programming 6/04