Toshiba Strata CTX28 Programming Manual page 450

Applications, Tips and Tricks
Networking Multiple Voice Mail Systems
• 02 PC Operation Type = Client
• 03 Data Flow = Asynchronization
• 04 Service Port No. = 0 (default)
• 05~08 Client IP 1-4 No. = 192.168.254.250
• 09 Client Port No. = 5000
• Client IP No. = Stratagy IP Address
• 10 Read Retry No. = 1
• 11 Write Retry No. = 1.
5. Click Submit.
Set up Remote CTX
Step 2:
1. From the Program menu, select Services > Voice Mail > Voice Mail Port Data. Program 580 – VM Port
Data displays.
2. Enter the appropriate fields. Refer to
3. Select Station > Assignment. Program 200 – Station Data screen displays.
4. Enter the Prime DN. For Call Record, enter the Node ID and Pilot number of the local CTX (where the
voice mail is located).
5. In FB22 – MW to VM Port, enter the local CTX IP address for call recording. For Remote CTXs,
assign message center including Node IP for TPI integration. This parameter enables Call Record
function too.
Refer to
Note
Set up QSIG Between All Nodes
Step 3:
Use the following programs to set up QSIG:
1. "304 Incoming Line Group Assignment"
2. "306 Outgoing Line Groups"
3. "302 PRI and IP QSIG"
4. "102 Flexible Access Codes"
5. "651 Private Routing Plan Analysis"
6. "653 Private Route Choice Table Assignment"
7. "654 Private Route Definition Table Assignment"
8. "655 Private Network Digit Modification Table Assignment"
9. "656 Node ID Assignment"
For all other voice mail set up steps refer to
A-4
"Voice Mail Set Up" on
on page
on page 6-25
on page 4-4
on page 9-54
"580 Voice Mail Port Data"
page A-1 for regular voice mail set up.
on page 6-2.
6-4.
on page 9-56
on page 9-57
on page 9-57
"Voice Mail Set Up"
Strata CTX Programming - Part 4: Appendices 6/04
on page 9-5.
on page 9-57
on page A-1.