Toshiba Strata CTX28 Programming Manual page 425

FB Name
Trace State 01
Trace Size 02
Trace Category 03
A7
1. Press to enable Start or Stop trace. Use the number key pad to make your selection.
‚yq
2. Press .
Notes
Start indicates the trace was previously started and is currently running.
Stop indicates the trace is not running and all trace buffer data was transferred to SmartMedia.
A7!
3. Press to enter trace file size. To change the setting, use the number Dial Pad.
‚yq
4. Press .
A7"
5. Press to set trace category. To view setting options, press the
‚yq
6. Press twice to execute. Wait for the
7. Enter another program number to continue programming or press
mode.
When CTX 670 stops logging data, it automatically sends data to the SmartMedia card. A new trace
Note
file is stored on SmartMedia under the Evnttrace directory. Run the Unmount command (Program
908) before removing the SmartMedia card to ensure complete data transfer.
Strata CTX Programming - Part 3: Telephone Button Programming 6/04
FB Summary
!
Enter or to Start or Stop Message
Trace. Stopping the trace outputs data to
the SmartMedia card. Wait for the
prompt on the LCD before proceeding.
Before removing the SmartMedia card run
Program 908. See "Format/Unmount
SmartMedia" on page
Set the trace data size. Toshiba
recommends leaving this parameter at the
default setting which provides
approximately 15 minutes of trace data.
Trace data type to be stored.
1:Start
2:Stop
52*
13-105.
1~256 (in bytes)
1 unit = 16 bytes.
default = 2
1:Call Processing
2:Maint and Admin
3:Both of the above
Ã
= prompt to display before proceeding.
PROG
ÆÃÆÃ ‚yq
Telephone Button Programming
900 Series Programs
Value LCD Prompt
1:START
2:STOP
SIZE=
1.CP
2.M&A
3.CP+M&A (default)
Tp…‚yy Qhtr
or button.
again to exit programming
13-101