Timer - Toshiba Strata CTX28 Programming Manual

Station
Assignment

Timer

Program Number(s): 208
Prerequisite Program:
Assigns timing parameters to Primary DNs.
1. Complete the
Record Sheets"
page D-18.
2. From the Program Menu
click Station > Assignment.
3. Click on the Timer tab
(shown right).
4. Enter a DN number in the
Primary DN field.
...or select an existing record
by clicking one of the
following buttons:
• List – view a summary
list of programmed
DKTs.
• Extended List – view a detailed list of programmed DKTs.
• Copy – Enter a DN in the Primary DN field and click Copy. Enter a new DN to assign existing
Station Timer settings.
5. Select the desired values. See descriptions below.
6. Click Submit.
F
IELD
Primary DN
01 ABR Retry Count
02 ABR Retry Interval
Timer
03 ABR Recall Timer
04 Hold Recall Timer
05 First Interdigit
Timer
5-22
200 page 5-1
"Station Data
on
D
ESCRIPTION
Enter the Primary DN.
Possible values: Up to 5 digits (default = no value)
Enter the number of retry attempts made by ABR when dialing a busy telephone
number.
Possible values: 5~20 (default = 15)
Select the amount of time (in seconds) ABR waits between dialing attempts.
Possible values: 30~180 (default = 60)
Select the number of seconds ABR will call back the station after receiving ring back
tone from the dialed number.
Possible values: 5~60 (default = 20)
Select the number of seconds before a call is placed on hold recalls.
Possible values: 0~255 (default = 60)
Select the amount of time a Station has to dial after going off hook before a call is
terminated (ROT is heard).
Possible values: 1~180 (default = 15)
Strata CTX Programming - Part 2: CTX WinAdmin Programming 6/04