Toshiba Strata CTX28 Programming Manual page 580

Software and Firmware Updates
IP Telephone/BIPU Firmware Update Procedures
11. Press the BIPU reset button for proper initialization.
IP Telephone Update
Important!
Copy the DIPXXXX file into the WinAdmin PC CTXIPUPDATE directory.
Notes
From the WinAdmin PC perform the update
Important!
1. Select IP Telephone > IPT Program Update.
2. Select the IPT PDN(s) to be updated.
3. Select Local WinAdmin (radio button).
4. Enter the Windows user login Name and Password.
If in doubt, create a new Window logon User Name and password and use it in Step 6.
Note
5. The IP address of the WinAdmin PC is inserted automatically.
6. Data Directory will be: CTXIPUPDATE
7. From File Name drop down box select: DIPUXXX
8. Click Start and observe the update status: Getting Updated file\Updating\Finished
Updating\Resetting\idle.
Notes
9. Select IP telephone > Station Data. Check the IPT version number to verify that all IPTs have been
updated properly.
10. To check the IP telephone firmware version directly from an IP telephone.
• Simultaneously press the
• At the SELECT = prompt, press
• At the Select function key prompt, press
• To exit this mode, go off and on hook.
Notes
E-6
Complete all "Prerequisites"
The directory location should be C:\Ctx\W inAdmin\CTXIPUPDATE The drive letter must be
the drive on which WinAdmin is installed.
(XXXX in the DIP file name is the firmware version level of the IP telephone).
The BIPUs and IPTs will automatically be disabled while Update takes place and return to
the idle state when Update is complete (if they were in the idle state when the Update was
started).
It could take 30 seconds to 2 minutes to update the IP telephone
If an error occurs, recheck file names, locations etc. and try again.
 +ROG
The WinAdmin PC cannot be connected directly to the CTX processor network jack.
All connections must be through the network.
on page E-4 before you do the following.
buttons on the IP Telephone.
 +ROG
then press .
)%
, the IP telephone will be displayed.
Strata CTX Programming - Part 4: Appendices 6/04