Limitations - Toshiba Strata CTX28 Programming Manual

Strata CTX Programming Guidelines
Step 1: Use Default Auto-programming to Start Up

Limitations

The following are the limitations of Strata CTX auto-programming.
• CTI programs are not programmed automatically.
• Strata CTX cannot configure unique LAN requirements automatically. Strata CTX's LAN system data,
CTX IP address and Community Name are set to a default.
DND is only assigned on 20-button telephones.
Note
• When the system is initialized, it takes a few minutes to recognize the mounted hardware.
• The Primary DN on the first button and DND on the last button are assigned telephone buttons; all other
buttons are not assigned automatically.
• Slot 101 must always have a BDKU, ADKU or PDKU. The BDKU is assigned if no PCB is installed.
Station and BIOU Auto-programming
Table 1-1 shows the Station and BIOU PCBs that will be recognized and set in Program 100 during auto-
programming.
No special assignments are set for BIOU during auto-programming.
Note
Important!
Table 1-1 Auto-Programming for Station and BIOU PCB Recognition (Program 100)
PCB Code
000
002 RSTU
003 PDKU2
004 Not used
017 BDKU
018 BDKU1+BDKS
019 BIOU
020 BIOU2
1-2
PCBs must be installed per the rules in the Strata CTX I&M manual, Configuration Chapter,
Worksheet 6 and Worksheet 7.
PCB Name PCB Circuit Type
No PCB or RRCU
8 Standard Telephone
circuits
8 Digital Telephone
Not used
8 digital telephones
16 digital telephones
Page/MOH/Relay
interface#1
Page/MOH/Relay
interface#2
Parameter
Setting
None or Remote Cabinets
Standard telephone no VM interface
settings
DKT2000 or DKT3000 without
S-OCA (DKT3000 limitations:
PCM DKT2000, 16 character LCD display
Highway: 8 on DKT3000, DKT3000 LCD Feature
key does not function, DKT3014
large screen LCD does not display).
DKT2000 or DKT3000 without
8, 1B circuits
S-OCA
DKT2000 or DKT3000 without
16, 1B circuits
S-OCA
No functions assigned
No functions assigned. Strata CTX
100 assigns a virtual BIOU2 into a
virtual location, Cabinet 02, Slot 05,
to provide control of the ACTU relay.
Strata CTX Programming - Part 1: Getting Started 6/04
Comments