Toshiba Strata CTX28 Programming Manual page 262

Services
Network Busy Lamp Field (BLF) (R1.3 and higher)
Program Network BLF from WinAdmin for CTX Attendant Console
Step 1:
Perform the all of the following steps on the local CTX first, then repeat them on each of the remote CTXs.
1. Create the Node ID in
If you have already created the Node ID using QSIG, skip Step 1 and go to the next step.
Note
2. Set up the IP address of the primary CTX using Program
3. From the Program menu, select Services > Networking > Node ID to set the Primary Node ID. Refer to
"656 Node ID Assignment"
4. From the Program menu, select System > I/O Device. Refer to Program
Assignments" on page
• 00 Logical Device No. = 400 (BLF)
• 01 Device Connection = LAN
• 02Device Port No. = 11
5. Define the LAN Device port number (11 in the example above). Select System > I/O Device, select the
LAN Device tab. Refer to
following selections:
• 00 LAN Port No. = 11
• 01 Protocol = TCP
• 02 PC Operation Type = Server
• 03 Data Flow = Asynchronization
• 04 Server Port No. = 6000
• 05~08 Client IP 1-4 No. = Default
• 09 Client Port No. = Default
• 10 Read Retry No. = 1
• 11 Write Retry No. = 1
9-46
"102 Flexible Access Codes"
on page 9-54.
4-31.
"801 Network Jack LAN Device Assignment"
Strata CTX Programming - Part 2: CTX WinAdmin Programming 6/04
on page 4-4.
"916 IP Configuration" on page
"803 SMDR SMDI CTI Port
on page
10-14.
4-33. Make the