F
IELD
Line Number
01 Line Equipment No.
02 Incoming Line Group
03 Outgoing Line Group
04 Dial Mode
05 Signaling
06 Start Method
07 Release Supervision
08 Answer Supervision
Strata CTX Programming - Part 2: CTX WinAdmin Programming 6/04
D
ESCRIPTION
Enter the Line Number.
Possible values: CTX28: Line 01~03 = 0102 (01~03); Line 04~06 = 0108 (01~03)
1~64 (CTX100), 1~96 (CTX670 Basic),
1~264 (CTX670 Exp.), (default = no value)
Enter the line equipment number as xxyyzz. Equipment numbers are required when
assigning a new trunk to the system. It can also be used to display the equipment
location of existing trunks.
Example: If the trunk should be connected to an RCOU in cabinet shelf 5, slot 2,
circuit 3, enter 050203.
Possible values: xx = Cabinet 01~07; yy = Slot 01~10; zz = Circuit 01~08
...or zz = T1 Circuit 01~24 (CTX670).
xx = Cabinet 01; yy = Slot 01~8; zz = Circuit 01~08 (CTX100)
(default = no value).
Cabinet numbers:
•
CTX100 – Select 01 for Base and Expansion cabinet.
•
CTX670 – Select 01 for Base and 02~07 respectively for each Expansion
cabinet.
Slot numbers:
•
CTX100 – Select 01~04 for Base slots and 05~08 for Expansion slots.
•
CTX670 – Select 01~08 for Base slots and 01~10 for Expansion slots.
Assign the trunk to Incoming Line Group. Two-way trunks need to be members of
one incoming and one outgoing line group.
Possible values: 0~32 (CTX100), 0~50 (CTX670 Basic), 0~128 (CTX670 Exp),
(default = 0)
Assign the trunk to Outgoing Line Group. Two-way trunks need to be members of
one incoming and one outgoing line group.
Possible values: 0~32 (CTX100), 0~50 (CTX670 Basic), 0~128 (CTX670 Exp),
(default = 0)
Enter the Dial Mode.
Possible values: DP 10PPS, DP 20PPS or DTMF (default)
•
DP 10 PPS = Rotary Dial, 10 PPS
•
DP 20 PPS = Rotary Dial, 20 PPS
Enter the signalling type.
Possible values: DID, Loop (default), Ground, Tie, LP (Japan), SR (Japan) or ACU
(UK)
Enter the Start Method. This setting defines the start protocol method used between
the PSTN and this trunk. For DID/Tie trunks.
Possible values: Immediate Start (default), Timing Start or Wink Start
Enable Release Supervision from the CO.
Possible values: Received or Not Received (default)
Enable Answer Supervision from the CO.
Possible values: Received or Not Received (default)
Trunks
300 Trunk Assignment
6-7