Telephone Button Programming
300 Series Programs
Table 13-31
Programs 318~320 (continued)
Button
Sequence
319
Intercept Treatment
" (
Cyq
,
319-00
Tenant Number
01
Day1 Destination
02
Day2 Destination
03
Night Destination
A7
A7"
~
, n,
Cyq
Cyq
n1,
,
320
B Channel
"
Cyq
,
320-00
RPTU Equipment No.
Cyq
xxyyzz,
320-
B Channel
01~23
A7
A7 "
~
, n,
Cyq
Table 13-32
B Channel Defaults
B Channel Position
Span Interface Speed
1.5M (T1)
2.0M (E1)
Table 13-33
Programs 321~324
Button
Sequence
321
Calling Number
Identification
"
Cyq
,
321-00
OLG Number
Cyq
n,
321-01
Default Number
A7
Cyq
, n,
13-70
Value(s)
n =
Enter 1~8
n =
1. None (default)
2. Dialing Digits
3. Night Bell
n1 =
Up to 32 digits
Tx
,
xx =
xx = cabinet 01
yy =
yy = 03, 05, or 07
zz =
zz = Channel 01 is always
used to assign RPTU
parameters
or
xx = cabinet 02~10
yy = 01, 03, or 05
zz = Channel 01 is always
used to assign RPTU
parameters
n =
1. Enable (default)
2. Disable
Cyq
,
01~15
ON
ON
Value(s)
n =
1~32 (CTX100)
1~50 (CTX670 Basic)
1~128 (CTX670 Exp.)
n =
Up to 10 digits
This command assigns Intercept positions for Strata CTX Day/Night
schedules. Intercept positions are used when the destination of a
trunk line call is not determined with DID or DIT
Select the Tenant number for which the Intercept Destinations will be
configured.
Select Destination Type for each.
Enter Destination for each.
•
To intercept with a DN use 0~99999
•
To intercept with a Network DN use 1~32
•
To intercept with Dial Digits Paging 1~16
PRI interfaces are purchased on per interface and channel basis. The
'B' channel assignments allow for a flexible activation of channels to
match the subscribed services from the Public Service Telephone
Network.This command allows you to enable or disable each B
channel on selected RPTU PCBs.
Enter the ISDN RPTU equipment number.
Equipment numbers are required when assigning ISDN RPTU
parameters in the system. It can also be used to display the
equipment location of existing RPTU PCBs.
Example: If the RPTU is installed in cabinet shelf 5, slot 3, enter
050301.
Assign each 'B' channel as enabled or disabled for each channel on
the interface. The assignments must match exactly to the
subscription from the PSTN.
16
17~23
ON
ON
OFF (Dch Pos)
ON
The Calling Number ID is what is defined as the user supplied Calling
Number. This number may be optionally screened by the PSTN to
ensure only calls from valid billable telephone numbers are allowed to
originate calls.
Enter the OLG Number.
Enter the telephone number to use by default when originating a call.
This is the number that the PSTN has registered for billing purposes.
Strata CTX Programming - Part 3: Telephone Button Programming 6/04
Summary
24
25~31
OFF (Dch Pos)
ON
ON
Summary