Toshiba Strata CTX28 Programming Manual page 312

Operation
License Information
F
IELD
Number Of Attendant
Consoles
Processor\Cabinet
Configuration
Number Of DTMF
Receivers
Number of Ports
Number of CTI
Sessions
10-22
D
ESCRIPTION
This identifies the number of Attendant Consoles licensed. One license
is required for each Attendant Console. A CTI Session License is also
required for each Attendant Console (see Number of CTI Sessions).
This identifies the CTX Processor hardware size
Small: ACTU, supports CTX100 Base + Expansion cabinet and CTX670.
ACTU2A-S, supports the CTX100-S.
BBCU\BECU without BBMS\BEXS, supports CTX670 Base + one Expansion
cabinet.
Large CTX670: BBCU\BECU with BBMS\BEXS, supports CTX670 Base + six
Expansion cabinets
This identifies the number of DTMF receivers licensed. The ARCS
Subassembly is required on the CTX100 processor, no additional hardware
is required for CTX670.
This identifies the number of Line circuits, Station circuits and ISDN B channels
licensed.
Station circuits use a license only when a PDN, DDS, BATI or Door Phone is
assigned to the circuit.
Analog and T1 line circuits use a license only when a line number is assigned to the
circuit or B-channel.
ISDN B-Channels use a license when assigned in PRI and BRI assignments.
This identifies the number of licensed CTI sessions. Each Attendant Console, the
ACD or OAISYS Sever and each third party CTI application requires one CTI
session license. (Command 803 assigns CTI sessions).
Strata CTX Programming - Part 2: CTX WinAdmin Programming 6/04