Toshiba Strata CTX28 Programming Manual page 60

Installation
Set Up LAN Connection to Strata CTX
Step 3: Set up Modem Connection (Optional)
Step 3A: Connect CTX WinAdmin PC to Strata CTX Modem
Connect an RJ11 cable from your PC modem to an active phone line or RSTU port. See
Local CTX
WinAdmin PC
Remote CTX
WinAdmin PC
Figure 3-4
CTX WinAdmin PC Modem to CTX Modem Call Setup – CTX Programming and Operation
• Direct ring connection over CO lines
• DID lines: in PRG 309, assign "Built-in Modem" as the Audio Day1, Day, and/or Night destination
type.
• DIT ground/loop start lines: in PRG 310 assign "Built-in Modem" as the Day1, Day2, and/or Night
destination type.
• Direct Ring when connected to RSTU or DISA line: put "#19" in CTX WinAdmin Phone Number
dial string.
• Transfer a CTX WinAdmin call to the Strata CTX modem from a CTX Auto Attendant or telephone
After receiving the call from the CTX WinAdmin user, press
hang up after receiving CTX modem tone.
If calling an Auto Attendant put "xxxxxxx,,,,,,,, #19" in CTX WinAdmin Phone Number dial string.
Note
Where "xxxxxxx" is the site phone number and each "," adds a three-second delay before dialing
#19 to connect to the modem.
Important!
3-10
RS-232 Cable
Modem
Modem
RS-232 Cable
CTX WinAdmin Modem Interface Connection
Windows XP: Choose Step 3B; Windows 2000: Choose Step 3C.
Point-to-point TCP/IP
33.6 kbps v.34
Dial #19
CO Line CO Line
Telephone
Network
Strata CTX Programming - Part 2: CTX WinAdmin Programming 6/04
Figure
BCTU,
BECU or
Flash
ACTU/
or ROM
AMDS
and
Modem
RAM
RSTU
Time
Switch
CO Line
Circuit
Strata CTX
QI7UQ
or hook flash and dial #19 then
3-43-4.
5592