Station Programming Error Codes - Toshiba Strata CTX28 Programming Manual

Station Programming Error Codes

Program Code
33
33
49
49
49
51
200
52
54
80
80
96
98
50
201
51
52
80
33
49
49
49
49
202
49
51
51
52
Strata CTX Programming - Part 4: Appendices 6/04
Sub-
FB
parameter
7
The entered Shelf/Slot/Circuit value is out of range.
7 !
The entered System Call Forward index is out of the range.
The selected PDN(s) conflicts with an existing PDN(s)
7
assignments for the selected circuit.
7!
Station Type cannot be changed.
7 $
The desired DN does not exist.
7!!
The entered value conflicts with an existing numbering
7
scheme.
The entered value conflicts with an existing ISDN assignment
7
etc.
The quantity of lines, ISDN channels and PDNs entered
7
exceeds the number of ports licensed with this processor.
7
The DN does not exist.
A PCB without "DKT/SLT setting allowed" is designated for a
7
PCB connecting the selected ISDN extensions.
7
The allowed number of extensions has been exceeded.
The quantity of station speed dial bins entered exceeds the
7"$
system's capacity.
The DN entered is the DN that is used as the administration

terminal.
FB which this error occur : FB01
7
The entered number is not the extension number.
7
The entered number is not the extension number.
7
The entered value is not a valid extension.
7
The equipment number entered is out of the range.
PCB assignment is not set for the ISDN card connecting
7
selected extensions.
7
The entered equipment is using as other ISDN extension.
7!
An ISDN trunk channel group conflict has been detected.
Although the P-P connection was selected, an additional DN
7!
is registered.
7!%— 7"!
The desired value conflicts with existing ISDN extensions.
The Primary DN entered conflicts with a value of an existing
-
numbering scheme.
7Ã 7!%Ã
The desired value conflicts with existing number schemes.
— 7"!
7
A DN used for DKT extensions is designated.
System Error Codes
Station Programming Error Codes
Error Descriptions
B-5