Toshiba Strata CTX28 Programming Manual page 15

Introduction
This manual provides information required to program the Strata CTX28, CTX100-S, CTX100
and CTX670 business telephone systems using Toshiba's CTX WinAdmin™ software or Button
Programming.
Whenever the CTX100 is mentioned in this book, it applies to both the CTX100-S
Important!
and CTX100, unless specified otherwise.
This programming manual only applies to CTX WinAdmin version 2.20G. If you
have CTX WinAdmin versions 2.1D or lower, refer to previous versions of this
manual.
The features described in this document assume that the Strata CTX system has the current
Note
software release installed. At the time of printing, Strata CTX R2.2 and CTX WinAdmin
R2.20 are the most current versions.
Organization
Part 1: Getting Started
Chapter 1 - Programming Guidelines describes auto-recognition features, order of
programming, and overview of general CTX WinAdmin and Button Programming operation.
Part 2: CTX WinAdmin Programming
Chapter 2 – CTX WinAdmin Overview provides general information about CTX WinAdmin's
software capabilities.
Chapter 3 – Installation discusses system hardware and software requirements for
CTX WinAdmin and includes the installation steps needed to install CTX WinAdmin.
Chapter 4 – System provides system programming information.
Chapter 5 – Station discusses station and station feature programming.
Chapter 6 – Trunks explains trunk programming information including T1, ISDN Basic Rate
Interface (BRI) and Primary Rate Interface (PRI).
Chapter 7 – Attendant describes Attendant Console support and settings available in
CTX WinAdmin.
Chapter 8 – IP Telephone describes the programs required to program IP Telephone features.
Strata CTX Programming 6/04
xi