Toshiba Strata CTX28 Programming Manual page 174

Trunks
309 Direct Inward Dialing
F
IELD
04 Pool Key Group
05 Audio Day1 Dst Type
06 Audio Day2 Dst Type
07 Audio Night Dst Type
Audio Day1 Destination
Audio Day2 Destination
Audio Night Destination
08 Data Day1 Dst Type
09 Data Day2 Dst Type
10 Data Night Dst Type
Data Day1 Destination
Data Day2 Destination
Data Night Destination
6-14
D
ESCRIPTION
If this line group is not assigned to ring a CO, GCO or a Pooled line key, enter the
Destination type that should ring:
No Data - no destination will ring when the line rings into the system.
Dialing Digits - assigns the line to ring the directory number or access code defined in
the 'Destination Digits' assignment.
DISA - assigns the line to ring in as a DISA call - DISA dial tone will be returned to the
caller.
Modem - assigns the line to ring the remote maintenance modem on the CTX
processor. Used to call into the system with a WinAdmin PC and modem.
Night Bell - Assigns the line to cause the night relay to pulse (one-sec.close/3-
sec.open)..
Possible values: 0~32 (CTX28 & CTX100), 0~50 (CTX670 Basic), 0~128 (CTX670
Exp),
(default = 0)
If this line group is not assigned to ring a CO, GCO or a Pooled line key, enter the
Destination type that should ring:
No Data - no destination will ring when the line rings into the system.
Dialing Digits - assigns the line to ring the directory number or access code defined in
the 'Destination Digits' assignment.
DISA - assigns the line to ring in as a DISA call - DISA dial tone will be returned to the
caller.
Modem - assigns the line to ring the remote maintenance modem on the CTX
processor. Used to call into the system with a WinAdmin PC and modem.
Night Bell - Assigns the line to cause the night relay to pulse (one-sec.close/3-
sec.open).
Possible values: No Data (default), Dialing Digits, DISA, Built-in Modem or Night Bell
Enter the Destination Directory Number or Access Code.
Possible values: Up to 32 digits (default = no value)
If Dialing Digits is the Destination Type enter the Directory Number that the line should
ring. If the line should ring over external page, enter #31xx, where xx is the external
Page group number. If the default page access code #31 was changed, use the new
page access code as the leading digits.
Line access codes and network routing numbers can also be entered to route incoming
calls back out to a public or private network number.
Select the Destination Type for data calls
Possible values: No Data (default), Dialing Digits, DISA, Built-in Modem or Night Bell
Enter the Destination Directory Number or Access Code.
Possible values: Up to 32 digits (default = no value)
If Dialing Digits is the Destination Type enter the Directory Number that the line should
ring. If the line should ring over external page, enter #31xx, where xx is the external
Page group number. If the default page access code #31 was changed, use the new
page access code as the leading digits.
Line access codes and network routing numbers can also be entered to route incoming
calls back out to a public or private network number.
Strata CTX Programming - Part 2: CTX WinAdmin Programming 6/04