Toshiba Strata CTX28 Programming Manual page 184

Hide thumbs Also See for Strata CTX28:
Table of Contents

Advertisement

Trunks
ISDN
F
IELD
15 Initialization Display
16 SPID #1
17 SPID #2
18 T-Wait Timer
19 Voice Calls
20 Trunk Subscriber 1
21 Trunk Subscriber 2
22 Layer 1 Short Break
Tolerant
23 TEI assignment
24 Malicious Call ID
Table 6-1
Bearer Capability Table
Circuit Mode
6-24
D
ESCRIPTION
Enter the text to be displayed for SPID Initialization.
Possible values: Up to 4 ASCII characters (default = User)
Enter the SPID value. These fields are required if you selected National ISDN in
Protocol. When no data is entered, any previously entered information is overwritten.
Possible values: Up to 20 ASCII characters (default = No Value)
Enable the T-Wait Timer. This field is needed if you selected National ISDN in Protocol
above. This timer, used along with the SPID, assigns random initializing SPID times to
prevent BRI interfaces from re-initialize at the same time after a reset or power
outage.
Possible values: Enable or Disable (default)
Select the number of simultaneous voice (speech) calls that can exist at the same
time on this interface.
Possible values: One or Two (default)
Enter the telephone number for subscriber 1. Telephone number should be consistent
with D channel data. If no data is entered in this field any previously programmed
information is lost.
Possible values: Up to 10 digits (default = no value)
Enter the telephone number for subscriber number 2. If no data is entered in this field
any previously programmed information is lost.
Possible values: Up to 10 digits (default = no value)
If layer 1 is interrupted for a short period of time CTX will ignore it
TEI assignment for ISDN CO Trunk
Leave in default
Possible values: TEI FIXED, SINGLE TEI or 3:TWO TEI (default)
Enable - to be allow Malicious Call ID to be sent by this terminal.
Disable - to not allow Malicious Call ID to be sent on this terminal.(also see Program
302-31)
Note: MCID supplementry service must be provided by PSTN for this feature to
operate.
Possible values: Enable or Disable (default)
Bearer Services
Speech
3.1 KHz
7 KHz
64 Kbps
Rate adaptation
Unrestricted
from 56 Kbps
Digital
Information
2x64 Kbps
Bellcore
ETSI
National ISDN
X
X
X
X
Strata CTX Programming - Part 2: CTX WinAdmin Programming 6/04
TTC
X
X
X
X
X
X
X
X
X
X

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Strata ctx670Strata ctx100-sStrata ctx100

Table of Contents