Toshiba Strata CTX28 Programming Manual page 328

Telephone Button Programming
Telephone Button Overview
Programming Sub-parameters
Some commands enable programming of Sub-parameters to further refine Strata CTX settings. Internet or
Network IP addresses are entered using sub-parameter data. IP addresses are displayed as four three-digit
values, or Octets, separated by "periods" (e.g.,
is only capable of displaying the IP information three digits, or one Octet, at a time.
For example, selecting
the next Octet (in this example
displays the following Octet (in this example
The following is an example from Program 200,
follows COS DAY1, COS DAY2 and COS NIGHT.
1. At the
SELECT PARAM
2. At the
COS DAY1=
Tƒx…
3. Press
4. At the
COS DAY2=
Tƒx…
5. Press
6. At the
COS NIGHT=
C‚yq
7. Press
8. Press another
...or press
To change one of the sub-parameters, you must proceed through all three sub-parameters before
Note
pressing
value, then press
13-4
A7
in Program 916 displays the first Octet,
168
) in the IP Address, press the
prompt, press
prompt, enter a value from 1~32.
.
prompt, enter a value from 1~32.
.
prompt, enter a value from 1~32.
to submit.
A7
button to program more parameters
C‚yq
again to program a new DN.
C‚yq
. For example, to change the value of COS DAY1, you must change the COS DAY1
Tƒx…
twice, and finally, press
192.168.255.253
Tƒx…
255
).
A7# A7#
. is broken down into three sub-parameters as
A7#
.
C‚yq
.
Strata CTX Programming - Part 3: Telephone Button Programming 6/04
). Your programming telephone's LCD
192
, on the LCD. To view or change
Tƒx…
button. Pressing again,