Toshiba Strata CTX28 Programming Manual page 153

F
IELD
08 LCR Group
10 Speech Capability
11 3.1 KHz Audio
12 7 KHz Audio
13 64Kbps
Unrestricted
14 56Kbps
Unrestricted
15 2 x 64Kbps
Unrestricted
16 B Channel
Selection
17 Idle B Channel
Selection
18 Interdigit Timer 1
19 Interdigit Timer 2
20 CESID
21 Number Voice Calls
Allowed
22 Service Tone
Permission
Strata CTX Programming - Part 2: CTX WinAdmin Programming 6/04
D
ESCRIPTION
Select the LCR Group number to which this BRI Station belongs.
Possible values: 1~16 (default = 1)
Enable speech capability. See
Possible values: Enable (default) or Disable
Enable 3.1 KHz audio capability. See
Possible values: Enable (default) or Disable
Enable 7 KHz audio capability. See
Possible values: Enable or Disable (default)
Enable one of the unrestricted capabilities. See
Possible values: Enable (default) or Disable
Select originating B Channel method.
Possible values:
•
Exclusive – (default) Channel is indicated, and no alternative is acceptable.
•
Preferred – Channel is indicated, and any alternative is acceptable.
•
Any Channel – Channel is indicated, and any channel is acceptable.
Choose Idle B Channel selection method.
Possible values: Forward Cyclic, Backward Cyclic, Forward Terminal or Backward
Terminal (default)
•
Select Forward Cyclic (from lowest to highest number of B-channel).
•
Select Backward Cyclic (from highest to lowest number of B-channel).
•
Select Forward Terminal for the lowest number B-channel (The Low-Low B-channel
selection).
•
Select Backward Terminal for the highest number B-channel. (The High-High B-
channel selection)
Select the Interdigit timer value, to time-out during dial tone.
Possible values: 1~180 (default = 15)
Interdigit timer value to time-out after the first digit is dialed.
Possible values: 1~180 (default = 5)
Enter the CESID value for 911 calls.
Possible values: Up to 16 ASCII characters (default = no value)
Select the Number of Voice Calls Allowed. If a selection is not made, previously written
data in this field is erased.
Possible values: One or Two (default)
Note If One is selected, the other channel is reserved for Data.
Enable Service Tone Permission. Select Disable for modems and faxes.
Possible values: Enable or Disable (default)
Table 5-5 on page 40.
Table 5-5 on page 40.
Table 5-5 on page 40.
Table 5-5 on
Station
ISDN
page 40.
5-39