Default Feature Access Codes - Toshiba Strata CTX28 Programming Manual

Strata CTX Programming Guidelines
Step 2: Plan Your System Requirements

Default Feature Access Codes

Refer to "102 Flexible Access Codes"
Step 2: Plan Your System Requirements
Plan for your Strata CTX system requirements in detail before beginning your installation. Use record
sheets wherever they are provided to document your installation requirements. The following are some
areas to consider:
• Flexible Numbering Plan (102) – Planning your Flexible Numbering requirements is essential to a
smooth installation. Trunk group access and station range requirements are especially important areas
of consideration.
• COS (103) – Determine the Class of Service (COS) requirements for your station and trunk groups.
There are up to 32 possible COS plans.
• DRL (111) – Define up to 16 Destination Restriction Level (DRL) assignments.
Important!
• FRL and QPL (506) – Define up to 16 Facilities Restriction Level (FRL) and Queuing Priority Level
(QPL) assignments.
Step 3: Program CTX for First Time
Follow the steps below to program the Strata CTX for the first time. Following this initial setup procedure
enables you to perform a standard Strata CTX setup with common System and Station default assignments.
Toshiba recommends adherence to these procedures for initial setup.
1. Card Assignments (100) – Choose System > Card Assignment. It is not necessary to physically install
PCBs prior to programming Strata CTX.
If you physically install your PCBs prior to initial setup, CTX WinAdmin automatically recognizes
PDKU, BDKU/BDKS, RSTU, RCOU/RCOS and RGLU PCBs and assigns default stations and trunks
automatically. All other PCBs are assigned manually. See
page 4-1
2. ILG Assignment (304) – Choose Trunk > ILG to assign Incoming Line Groups (ILG). See
Incoming Line Group Assignment"
Class of Service features for incoming call handling.
3. OLG Assignment (306) – Choose Trunk > OLG to assign Outgoing Line Groups (OLG). See
Outgoing Line Groups"
4. Trunk Assignment (300) – Choose Trunk > Basic. Set up your Trunks in the following order (see
Trunk Assignment"
• Loop Start Trunks
• Ground Start Trunks
• T1 Trunks
• Tie lines
• FX lines
1-12
Destination Restriction is an expanded feature of what has traditionally been known as Toll
Restriction. Toll Restriction is only one facet of Strata CTX's Destination Restriction feature.
Refer to Destination Restriction in this manual when programming Toll Restriction
requirements.
for more details.
on page 6-4
on page 6-6 for more details):
on page 4-4.
"100 Cabinet Slot PCB Assignments"
on page 6-2 for more details. ILGs enable line groupings of shared
for more details.
Strata CTX Programming - Part 1: Getting Started 6/04
on
"304
"306
"300