Toshiba Strata CTX28 Programming Manual page 479

Program Code
315
33
49
33
33
49
49
316
52
54
80
80
33
33
33
49
49
49
49
50
317
52
54
80
80
80
80
96
Strata CTX Programming - Part 4: Appendices 6/04
Occurred Sub-
FB parameter
7
"NONE" entered in any field is invalid.
7!
7#
7$
7"
The entered equipment value is invalid.
The PCB installed in the designated Shelf/Slot must be a
7
RDTU.
7
The channel group entered is out of the range.
7
RPTU Equipment Number entered is invalid.
When the equipment is moved, the number of the PCM
7
highway in the moved equipment is different from the current
equipment.
If the Span Interface speed is set to a value not equal to 1.5M,
7#
the Dch position is modified.
The entered channel group number conflicts with an existing
7
ISDN extension(s).
7
The equipment number entered is out of range.
The entered channel group number does not exist in the
7
system.
7
The entered circuit must be an assigned ISDN.
7
The entered equipment value is invalid.
7"
The ILG entered is out of the range.
7#
The OLG entered is out of the range.
7"
"0" was entered in ILG when OLG was not registered.
7"
The entered ILG/OLG values do not have ISDN assignments.
7#
7#
The OLG entered is not registered in the system.
7#
"0" was entered in OLG when ILG was unregistered.
The T-Wait Timer can only be enabled if the Protocol is set to
7 '
National ISDN.
The entered channel group number conflicts with an existing
7
ISDN extension(s).
The quantity of lines, ISDN channels and PDNs entered
7
exceeds the number of ports licensed with this processor.
The entered channel group number does not exist in the
7
system.
7
The entered circuit must be an assigned ISDN.
7"
The entered ILG number does not exist in the system.
7#
The entered OLG number does not exist in the system.
The allowable channel group assignments exceed the system
7
capacity.
System Error Codes
Trunk Programming Error Codes
Error Descriptions
B-17