Toshiba Strata CTX28 Programming Manual page 24

Strata CTX Programming Guidelines
Step 1: Use Default Auto-programming to Start Up
Table 1-3 Auto-Programming for CO line PCB Recognition (Program 100) (continued)
PCB
PCB Name
Code
009 RCIU2+RCIS
010 RMCU+RCMS
011 REMU, BVPU
012 RBSU
013 RBSU+RBSS
014 RPTU
015 RBUU
016 RBUU+RBUS
1. If the slot next to an installed RDTU or RPTU is vacant, 24 line or channels will be installed; If the slot next to
an installed RDTU or RPTU is occupied by another PCB, 16 lines or channels will be installed.
Table 1-4 Auto-Programming of Line Groups and Service Types
CO line type
RCOU/RCOS and RGLU analog loop
and ground start
RDDU analog DID
RDTU (T1)
RMCU/RMCS analog CAMA
RBUU/RBUS and RBSU ISDN BRI -
set as CO side
ISDN PRI
REMU analog E&M
1. The line number is assigned to all lines in the numerical order according to the line PCB cabinet placements.
Example: Line number 1 will be on the first circuit of the line PCB placed in the lowest cabinet/slot number.
2. OLG:1 is created even if there is are no analog line PCBs installed.
1-4
PCB Circuit Type Parameter setting
4 or 8 Caller ID
interface
2 or 4 E911 analog
CAMA lines
4 analog Tie lines, 4
VoIP circuits
TIE Type:
2 ISDN BRI (S/T)
circuits
Two TIEs
TEI Type:
4 ISDN BRI (S/T)
circuits
Two TIEs
PCM Highway:
16 or 24 ISDN PRI
channels
16 or 24
TEI Type:
2 ISDN BRI (U)
circuits
Two TIEs
TEI Type:
4 ISDN BRI (U)
circuits
Two TIEs
OLG
Prg 306 Prg. 304
1
1
1
1
2
2
3
Caller ID interface for RCOU/RCOS
and RGLU analog CLID lines. Note:
The same Prg100 code (009) is used
for RCIU2 with or without RCIS.
CAMA lines Note: The same Prg100
code (009) used for RCIU2 with or
without RCIS.
Tie lines
ISDN BRI CO lines
ISDN BRI CO lines
ISDN BRI CO lines
1
ISDN BRI CO lines
ISDN BRI CO lines
ILG
CO Service Type
Direct In Termination (DIT) to the first PDN.
1
(200 or 2000 – see Table 5)
2 DID, wink – no default DID numbers
3 DID – no default DID numbers
Direct In Termination (DIT) to the first PDN.
-
(200 or 2000 – see next table)
4 DID – no default DID numbers
5 DID – no default DID numbers
6 Non-QSIG
Strata CTX Programming - Part 1: Getting Started 6/04
Comments