Caller Id - Toshiba Strata CTX28 Programming Manual

313 Caller ID

Prerequisite Program:
This program assigns Caller ID circuits to the CO Line to which the circuit is connected. The ANI, DNIS,
DID formats for TI and analog DID CO Lines are also defined.
1. Complete the "Caller ID
Assignment Record Sheet"
page D-24.
2. From the Program Menu, click
Trunk > Assignment, the click the
Caller ID tab. The Trunk Caller ID
Assignments screen displays
(shown right).
3. Enter a Trunk Number in Trunk
Index for an existing record or click
one of the following buttons:
• List – to view a summary list of
programmed Trunks.
• Copy – Enter the Trunk Number
in the Trunk Number field and click Copy to make new Caller ID trunk numbers.
4. Enter Caller ID Assignment data.
5. Click Submit.
F
IELD
Trunk Number
01 Signaling Method
02 Signaling Contents
03 CLASS Equipment No.
Strata CTX Programming - Part 2: CTX WinAdmin Programming 6/04
300 page 6-6
on
D
ESCRIPTION
Enter the Trunk Number.
Possible values: 1~64 (CTX100), 1~96 (CTX670 Basic),
1~264 (CTX670 Exp.), (default = no value)
Specify the format for the interface being used.
Possible values: Nothing (default), ANI/DNIS-MCI, ANI/DNIS-Sprint or CLASS
(Caller ID)
Specify the contents of the ANI/DNIS format.
Possible values: ANI and DNIS, ANI only, DNIS only or DID only (default = no
value).
If the CLASS type is chosen, the trunk must be assigned to a Caller ID circuit. Enter
the RCIU/RCIS equipment number as xxyyzz.
Possible values: xx = Cabinet 01(CTX100); 01~02 (CTX670 Basic); 01~07
(CTX670 Exp.)
yy = Slot 01~08 (CTX100); 01~10 (CTX670)
zz = Circuit 01~08
Notes
• CLASS equipment numbers are required when assigning a trunk to a RCIU/
RCIS circuit.
• It can also be used to display the equipment location of existing caller ID circuit
to trunk assignments. Example: If the trunk should be connected to a caller ID
circuit (RCIU/RCIS) in cabinet shelf 5, slot 2, circuit 3, enter 050203.
Trunks
300 Trunk Assignment
6-9