Toshiba Strata CTX28 Programming Manual page 186

Trunks
ISDN
F
IELD
01 RPTU Equipment No.
02 Protocol
03 ILG
04 OLG
05 Trunk ID Type
06 Trunk ID
6-26
D
ESCRIPTION
Enter the ISDN RPTU, BPTU or BIPU-Q equipment number as xxyyzz.
XX=cabinet 01~07
YY=slot 01~10
ZZ=T1channel 01~24. (default = no value)
Cabinet numbers:
CTX100: Select 01 for Base and Expansion cabinet.
CTX670: Select 01 for Base and 02~07 respectively for each Expansion cabinet.
Slot numbers:
CTX100: Select 01~04 for Base slots and 05~08 for Expansion slots.
CTX670: Select 01~08 for Base slots and 01~10 for Expansion slots.
Note zz = Channel 01 is always used to assign RPTU, BPTU or BIPU-Q
parameters
Example: If the RPTU is installed in cabinet shelf 5, slot 3, enter 050301. Enter the
equipment number xxyyzz to which the ISDN PRI Trunk is to be assigned.
Equipment numbers are required when assigning ISDN RPTU parameters in the
system. They can also be used to display the equipment location of existing RPTU
PCBs.
The Protocol to be followed defines the type of interface expected based upon the
equipment type at the distant end of the connection.
In North America, the choices are 1-Bellcore National ISDN; 4-Bellcore National
ISDN NT; or 5-Q-Sig.
Use IP for BIUP-Q, IP Qsig.
Use QSIG for RPTU/BPTU, PRI Qsig
Possible values: National ISDN, ETSI, TTC, National ISDN Nortel or Q-Sig
(default = None)
ISDN and IP Qsig need to have Trunk Group assignments to process the calls
being received. If multiple trunk groups are used within the Channel Group, then
Call-by-Call Services must be used.
Possible values: 0~32 (CTX100), 0~48 (CTX670 Basic), 0~128 (CTX670 Exp),
(default = 0)
ISDN and IP Qsig needs to have Trunk Group assignments to process the calls
being originated. If multiple trunk groups are used within the Channel Group, then
Call-by-Call Services must be used.
Possible values: 0~32 (CTX100), 0~48 (CTX670 Basic), 0~128 (CTX670 Exp),
(default = 0)
Identify whether the communication with the PSTN requires an identifier. Select
Explicit to require an identifier.
Possible values: Implicit (default) or Explicit
An identifier must be used as part of the addressing when an "explicit" identified is
used to communicate with the PSTN which channel on which link is used for the
given call. This identifier is assigned by the connected PSTN.
Possible values: 0 ~ 126 (default = 0)
Strata CTX Programming - Part 2: CTX WinAdmin Programming 6/04