Toshiba Strata CTX28 Programming Manual page 168

Trunks
300 Trunk Assignment
F
IELD
09 Trunk Name
10 External Ring Repeat
11 DTMF Back Tone
12 Hunt Order
13 Immediate Cut-Through
14 CO Line Guard Time
6-8
D
ESCRIPTION
Enter the trunk name.
Possible values: Up to 14 ASCII characters (default = no value)
This option determines what ring signal is sent to telephones when a line rings the
telephone. Select CO Ring Repeat ("Supplied" in older versions of software) to use
the ring signal supplied by the CO or Centrex line. Select CTX Ring ("Not Supplied"
in older versions of software) to use the standard ring signal supplied by the CTX.
Important!
CTX Ring must be used on all DISA lines for proper ringing operation.
Possible values: CO Ring Repeat (default), CTX Ring
Select DTMF Back Tone type.
Possible values: Padded, DTMF Tone (default) or No Tone
Change the trunk hunting order sequence for this Trunk.
Possible values: 1~264 or Last One (default = 1)
This option should be enabled on a line only if the talk-path must be established
immediately after seizing a selected outgoing line.
Example, a line connected to a Central Office Ringdown circuit.
Possible values: Enable, Disable (default)
CAUTION! This option will bypass Destination Restriction and E911
digit analysis. Do not enable this option on a line where
these functions are required.
This option is available only on ground and loop, analog or T1 circuits. It should not
be enabled for Tie, DID, ISDN and QSIG lines.
Available with CTX R1.02, MA217 and above software.
The interval between the release of a CO line and its eligibility to be seized again.
Strata CTX Programming - Part 2: CTX WinAdmin Programming 6/04