Print Features In The Esc/P Mode; Multiple Up (Esc/P); Form Overlay - Xerox Phaser 5335 Printing Manual

Print Features in the ESC/P Mode

The following print features can be used in the ESC/P emulation mode.

Multiple Up (ESC/P)

Multiple Up is a feature that prints multiple pages onto one sheet of paper.
In the ESC/P emulation mode, you can perform 2-up printing.

Form Overlay

Form Overlay is a feature that allows you to store forms in the printer and merge
them with print data when printing. When using this feature, select a form you want
to use on the control panel.
Barcode (ESC/P)
The ESC/P emulation mode allows you to use barcodes. The following barcode
standards are supported:
• OCR-B
• JAN code
• CODE39
• NW7 (CODABAR)
• Industrial 2 of 5
• ITF (Interleaved 2 of 5)
• CODE128
• Customer barcode
• QR code
About Forms
The following number of forms can be registered in the ESC/P emulation mode.
Hard disk installed
Hard disk not installed
NOTE: If you attempt to register a form when the printer already has the maximum number
of forms, or when the memory is not sufficient to store the form, the printer does not
register the form without showing any error.
Whether forms have been registered successfully can be checked by printing out the [User
Defined List]. For information about the [User Defined List], refer to the [User Defined List]
section in the User Guide.
ESC/P
64
64
Using ESC/P Emulation
67